Loop a part

Select a part of the piece, such as a difficult bar or a chorus, and let the player play it over and over.

Select a part

1. Tap the Select playable part button (arrows in two directions) next to the playback controls. A slider with two handles appears above the controls, with the start and end time.
2. Drag the left handle to where the part should start and the right one to where it should end.
3. Turn on loop if the part should be played over and over.

You can also set the start and end while you listen:

1. Play and pause where the part should start. Tap Set start from current position (the button to the left of the slider).
2. Play on and pause where the part should end. Tap Set end from current position (the button to the right of the slider).

The music is then only played within the selected part. With loop on, it starts again from the start of the part when it reaches the end.

Remove the part

• Tap Reset part selection (the button between the two buttons by the slider). The whole piece is played again.
• Or tap Select playable part again. The slider closes and the part is removed.
• Reset mix and playback settings in the mixer also removes the part.

Good to know

• The mobile app remembers the selected part and whether the loop is on for each arrangement. If you open the arrangement again, the slider is shown with the same part.
• The Home and End keyboard shortcuts in the web app jump to the start and end of the selected part.

Tips

• Select a short part and lower the tempo until you know it, then raise the tempo step by step.
• Start the part a few bars before the difficult place, so you get the entry too.

Related articles

• Playback controls
• Tempo
• The mixer